ISO IEC 22536:2013 pdf free
ISO IEC 22536:2013 pdf free.Information technology – Telecommunications and information exchange between systems
ISO IEC 22536 is part of a suite of standards that specify tests for ISO/IEC 18092. It defines test methods for the RF interface. This International Standard specifies RF-test methods for NFCIP-1 devices with antennas ftting within the rectangular area of 50 mm by 40 mm.
This test standard, the first of two parts, specifies compliance tests for the RF interface of ISO/IEC 18092 devices. The companion test standard ISO/IEC 23917 specifies protocol tests for ISO/IEC 18092.
A system implementing ISO/IEC 18092 is in conformance with ISO IEC 22536 if it meets all the mandatory requirements specified herein.
The following referenced documents are indispensable for the application of this document. For dated references，only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO/IEC 18092:-1 ，Information technology 一Telecommunications and information exchange between systems一Near Field Communication一Interface and Protocol (NFCIP-1)
ISO/IEC 10373-6:2011, Identification cards一Test methods一Part 6: Proximity cards
The purpose of this test is to verify that the modulation index of the Initiator field as well as the rise and fall times and the overshoot values for all bit rates are as specified in 9.2.1.2 and 9.2.2.2 of ISO/IEC 18092 within the defined operating volume.
The test report shall give the measured modulation index of the Initiator field, the rise and fall times and overshoot values, within the defined operating volume in unloaded and loaded conditions.
Initiator load modulation reception in passive communication mode
The purpose of this test is to verify that the Initiator detects the load modulation of a Target as specified in 9.3.2.2 and 9.3.3.2 of ISO/IEC 18092.
Under the conditions defined in 8.5.3.1 the Initiator shall detect the modulation waveform sent by the test assembly and continue normal operation.
The test report shall confirm the intended operation of the Initiator. Used test conditions shall be mentioned in
the test report.
Initiator maximum loading effect test in active communication mode (Optional)
The purpose of this test is to understand that the loading effect of the Initiator during reception in active communication mode is whether less or more than that of the Reference Device.
As defined for the Class 3 PICC in ISO/IEC 10373-6:2010/Amd.1, 7.2.4.2 and a DC voltage at CON3 of 4,5 V.ISO IEC 22536 pdf download.
