ISO 6747:2013 pdf free
ISO 6747:2013 pdf free.Earth-moving machinery一Dozers一Terminology and commercial specifications
This International Standard establishes terminology and the content of commercial literature pecifications for self-propelled crawler and wheeled dozers and their equipment.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 5010, Earth-moving machinery一Rubber-tyred machines一Steering requirements
ISO 6014, Earth-moving machinery一Determination of ground speed
ISO 6746-1, Earth-moving machinery一Definitions of dimensions and codes一Part 1: Base machine
ISO 6746-2, Earth-moving machinery一Definitions of dimensions and codes一Part 2: Equipment and attachments
ISO 7457, Earth-moving machinery一Determination of turning dimensions of wheeled machines
ISO 9249:2007, Earth-moving machinery一Engine test code一Net power
ISO 15550:2002, Internal combustion engines一Determination and method for the measurement of engine power一General requirements
mass of the base machine without an operator, with the fuel level at 10 % of tank capacity or with the minimum fuel level needed for machine shipping purposes as specified by the manufacturer, whicheveris higher, with all fluid systems at the levels specified by the manufacturer and with or without equipment,ballast, attachment, cab, canopy, operator-protective structures, wheels and counterweights as stated by the manufacturer
Note 1 to entry: If the manufacturer intends that the machine be partially disassembled for shipping purposes,the masses of the disassembled items will also be stated.[SOURCE: ISO 6016:2008, 3.2.6, modified一The expression “and with empty sprinkler tank(s), when applicable” has been omitted.]
power obtained on a test bed at the end ofthe crankshaftor its equivalent, at the corresponding engine speed,with the equipment and auxiliaries listed in ISO 15550:2002, Table 1, column 2, and required in column 3 [SOURCE: ISO 9249:2007, 3.7]
maximum speed that can be obtained on a hard level surface in each of the forward and reverse gear ratios available with the machine at its operating mass, as determined in accordance with ISO 6014
horizontal towing force exerted at the drawbar/hitch point, expressed in kilonewtons [SOURCE: ISO 7464:1983, 3.2]
<machine> maximum slope, expressed in degrees, that the machine fluid system(s) can operate on without malfunction or damage of any fluid system, at all machine orientations specified in 3.3.4.1 and 3.3.4.2.ISO 6747 pdf free download.
