ISO 5002:2013 pdf free
ISO 5002:2013 pdf free.Hot-rolled and cold-reduced electrolytic zinc-coated carbon steel sheet of commercial and drawing qualities
ISO 5002 specifies the characteristics of carbon steel sheet of commercial and drawing qualities in cut length or coil form, zinc coated by electrolytic deposition. Electrolytic zinc-coated sheet is intended for the manufacture of formed or of miscellaneous parts, and can be supplied chemically treated to render it more suitable for painting. The zinc coating is expressed in micrometres of thicknessper side, for equally coated, differentially coated, or one-side-coated sheets. These sheets are generally produced with coatings, which are not intended to withstand outdoor exposure without chemical treatment and painting. Electrolytic zinc-coated sheet can be produced in thicknesses of 0,36 mm and thicker (normally up to 4,0 mm) and in widths of 600 mm and over in coils or cut lengths. It is recognized that materials thinner than 0,36 mm or thicker than 4,0 mm can be suitable for electrolytic zinc coating, and, if required, be the subject of agreement between the interested parties.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 6892-1, Metallic materials一Tensile testing一Part 1: Method of test at room temperature
ISO 7438, Metallic materials一Bend test
ISO 16160, Hot-rolled steel sheet products一Dimensional and shape tolerances
ISO 16162, Cold-rolled steel sheet products一Dimensional and shape tolerances
An analysis of each heat of steel shall be made by the manufacturer in order to determine compliance with the requirements given in Tables 1, 2 and 3. On request, at the time of ordering, this analysis shall be reported to the purchaser or his representative. Each of the elements listed in Tables 1 and 2 shall be included in the report of the heat analysis. If one or more of the elements in Table 3 is/are specified, the analysis shall be reported.
A product analysis may be made by the purchaser to verify the specified analysis of the semi-finished or finished steel, and shall take into consideration any normal heterogeneity. The sampling method and deviation limits shall be agreed upon between the manufacturer and the purchaser at the time of ordering. The product analysis tolerances shall be in accordance with Table 3 and Table 4.ISO 5002 pdf download.
