ISO 10649-1:2013 pdf free
ISO 10649-1:2013 pdf free.Cutter arbors with parallel key and tenon drive一General dimensions
This part of ISO 10649 specifies the dimensions of tool interface for cutter arbors with parallel key and tenon drive.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 2768-1, General tolerances- Part 1: Tolerances for linear and angular dimensions without individual tolerance indications
ISO 2768-2, General tolerances 一Part 2: Geometrical tolerances for features without individual tolerance indications
ISO 2780, Milling cutters with tenon drive一Interchangeability dimensions for cutter arbors一Metric series
ISO 10643, Dimensions of accessories for cutter arbors with parallel key and tenon drive
3 Dimensions
3.1 General
All dimensions and tolerances are given in millimetres. Tolerances not specified shall be of tolerance class “m”in accordance with ISO 2768-1 and of class “K” in accordance with ISO 2768-2.
The figures are schematic and are not intended to specify a given design; only the given dimension shall be met.
The interchangeability dimensions of the milling cutter bearing on the cutter arbors shall be in accordance with ISO 2780.
3.2 Dimensions of tool interface for arbors with parallel key and tenon drive
The dimensions of tool interface for arbors with parallel key and tenon drive shall be in accordance with the dimensions shown in Figure 1 and given in Table 1.
As this part of ISO 10649 does not define an entire product, the relationship between the symbols of this part of ISO 10649 and symbols according to the ISO 13399 series are not given. They are given in the entire product standards ISO 10649-2, ISO 10649-3, ISO 10649-4, ISO 10649-5 and ISO 10649-6, and future parts to be developed.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received. www.iso.org/ patents.ISO 10649-1 pdf download.
