ISO 10582:2017 pdf free
ISO 10582:2017 pdf free.Resilient floor coverings一Heterogeneous poly floor covering一Specifications
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 105-B02, Textiles一Tests for colour fastness一Part BO2: Colour fastness to artificial light: Xenon arc fading lamp test
ISO 4918, Textile floor coverings 一Determination of wear一Castor chair test
ISO 16906, Resilient floor coverings一Determination of seam strength
ISO 23997, Resilient floor coverings一Determination of mass per unit area
ISO 23999, Resilient floor coverings 一Determination of dimensional stability and curling after exposure to heat
ISO 24340, Resilient floor coverings一Determination of thickness of layers
ISO 24341, Resilient and textile floor coverings一Determination of length, width and straightness of sheet
ISO 24342, Resilient and textile floor-coverings一Determination of side length, edge straightness and squareness of tiles
After 25 000 cycles, no delamination shall occur. No disturbance to the surface other than a slight change in appearance. Record any damage caused by detachment of layers,opening of joints, or crazing. Ignore any flat-tening or change in appearance, e.g. change in gloss.For tiles/planks intended for loose laid or float-ing installationd, test should be performed with floor specimens fixed only in their perimeter for products aimed to be installed without any fixation to the subfloor. For products aimed to be installed with an adhesive, test should be performed with floor specimens fixed with an adequate adhesive (see footnote c).Take a representative sample from the available material. The test area shall include at least one short side joint in the path of the castor when the specimens are assembled according to the manufacturer’s instructions.An example of an assembled test area for planks is shown in Figure 1. The dimension I shall be at least 300 mm.For rolls, the test should include at least one side joint in the path of the castor. For tiles,the test should include at least two joints crossed in the path of the castor. In any case,the sample should allow mounting according to Figure 2.The diameter of the test area shall be at least 750 mm.ISO 10582 pdf download.
