ISO 10045:2017 pdf free
ISO 10045:2017 pdf free.Alpine skis一Binding mounting area一Requirements for test screws
This document specifies the dimensions, mechanical properties and fastening characteristics of test screws used for testing the binding mounting area of alpine skis.
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 1478, Tapping screws thread
ISO 4042, Fasteners一Electroplated coatings
ISO 4757, Cross recesses for screws
ISO 6004, Alpine skis一Ski binding screws一Requirements
ISO 6005, Alpine skis一Ski binding screws一Test methods
EN 10084, Case hardening steels一Technical delivery conditions
For the purposes of this document, the definitions given in ISO 6004 and the following definition apply.ISO and IEC maintain terminological databases for use in standardization at the following addresses:
一IEC Electropedia: available at http://www.electropedia.org/
一ISO Online browsing platform: available at https://www.iso.org/obp
fastener, which is used for testing the binding mounting area and for ensuring the comparability of measurement data
Designation of a test screw according to this document with a nominal diameter of 5,4 mm and a length of 12 mm:
test screw ISO 10045一TBS5,4x 12.
The strength requirements and typical application characteristics shall be tested according to ISO 6005.
The cross-section of the screw may be circular or non-circular within the major diameter of 5,31 mm to 5,46 mm (see Figure 1).
The thread length shall be at least 1 mm longer than the penetration depth, irrespective of the shaft length. The tolerance on the length of the screw shall be +0,5 mm.The shaft end shall correspond to Figure 1.
Test screws shall have a zinc electroplated coating, Fe/Zn 5c (according to ISO 4042), with a clear chromate conversion coating and a thickness of 10 μm when measured on the top surface of the screw head.
Adequate precautions shall be taken during electroplating to avoid hydrogen embrittlement.
The breaking moment for test screws under a torque of the same axis and direction as the driving torque shall be not less than 10 Nm.ISO 10045 pdf free download.
