BS ISO 9448-10:2013 pdf free
BS ISO 9448-10:2013 pdf free.Tools for pressing一Guide bushes一Form E, gliding bushes, flanged, type 2
This part of ISO 9448 specifies the main dimensions and tolerances, in millimetres, of guide bushes of form E, flanged gliding bushes, type 2, intended for use in press tools with guide pillars with a tolerance on d1 of g6 according to ISO 9182-3, and to be mounted in the clamp plate with transition fit and fixed to
the plate by means of guide clamps.
It gives guidance on the materials, and specifies the hardness and the designation of bushes in accordance with this part of ISO 9448.
2，Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 9182-3, Tools for pressing一Guide pillars一Part 3: Type B, end-locking pillars
3 Dimensions
The dimensions of type 2 flanged gliding bushes (form E) shall conform to the indications of Figure 1 and Table 1.
Details not stated, such as chamfers, radii and lubrication grooves, are left to the manufacturer’s discretion.
a Intended to fit into a hole having a tolerance of H7. When the bushes are glued, tolerance j6 is per-mitted.
b The value of the radius is at the manufacturer’s discretion.
c Number of guide clamps at the manufacturer’s discretion.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received. www.iso.org/ patents
Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.BS ISO 9448-10 pdf download.
