BS ISO 8132:2014 pdf free
BS ISO 8132:2014 pdf free.Hydraulic fluid power一Mounting dimensions for accessories for single rod cylinders
BS ISO 8132 specifies the mounting dimensions required for the interchangeability of accessories for 16 MPa [160 bar] medium series cylinders in accordance with ISO 6020-1 and for 25 MPa (250 bar) series cylinders, in accordance with ISO 6022. The accessories have been designed specifically for use with cylinders manufactured in accordance with ISO 6020-1 and ISO 6022, but this does not limit their application.
NOTE 1 bar= 0,1 MPa= 105 Pa; 1 MPa= 1 N/mm2
This International Standard covers the following accessories, identified in accordance with ISO 6099:
一AP2一rod clevis, female thread (see Figure 1 and Table 1);
一AF3 一rod flange, circular (see Figure 2 and Table 2)
一AB4 一clevis bracket, straight (see Figure 3 and Table 3);
一AB3 一clevis bracket, in angle (see Figure 4 and Table 4);
一AT4 一trunnion bracket (see Figure 5 and Table 5);
一AA4-R 一pivot pin, plain (cotter pin or snap ring type) (see Figure 6 and Table 6);
一AA4-S 一pivot pin, plain (split pins) (see Figure 7 and Table 7);
一AA6-R 一pivot pin, spherical bearing (cotter pin or snap ring type) (see Figure 6 and Table 6);
一AA6-S 一pivot pin, spherical bearing (split pins) (see Figure 7 and Table 7);
一AP6 一rod eye spherical, female thread (see Figure 8 and Table 8);
一AP4 一rod eye plain, female thread (see Figure 9 and Table 9).
These accessories are used on hydraulic cylinders for mechanically transmitting the cylinder force.The design of these accessories is based on the maximum forces resulting from the specified internal diameters of the cylinders and pressures according to ISO 3320 and ISO 3322.
BS ISO 8132 applies only to the dimensional criteria of products manufactured in conformity with this International Standard; it does not apply to their functional characteristics.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 286-2, Geometrical product specifications (GPS)一ISO code system for tolerances on linear sizes一Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
ISO 2768-1, General tolerances一Part 1: Tolerances for linear and angular dimensions without individual tolerance indications.BS ISO 8132 pdf download.
