BS ISO 7134:2013 pdf free

BS ISO 7134:2013 pdf free.Earth-moving machinery一Graders一T erminology and commercial specifications
BS ISO 7134 establishes terminology and the content of commercial literature specifications for graders and their equipment.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 5010, Earth-moving machinery一Rubber-tyred machines一Steering requirements
ISO 6746-1, Earth-moving machinery一Definitions of dimensions and codes一Part 1: Base machine
ISO 6746-2, Earth-moving machinery – – Definitions of dimensions and codes一Part 2: Equipment and attachments
ISO 7457, Earth-moving machinery – – Determination of turning dimensions of wheeled machines
ISO 15550:2002, Internal combustion engines一Determination and method for the measurement of engine power一General requirements
For the purposes of this document, the terms and definitions given in ISO 6746-1 and ISO 6746-2, and the following apply.
self-propelled wheeled machine with an adjustable blade positioned between the front and rear axles, which can be equipped with a front-mounted blade or scarifier that can also be located between the front and rear axles
mass of the base machine, equipment specified by the manufacturer, operator (75 kg), full fuel tank and full lubricating, hydraulic and cooling systems
mass of the base machine without operator, with full lubricating, hydraulic and cooling systems, 10 % of fuel tank capacity and with or without equipment, cab, canopy and/or operator protective structure, as stated by the manufacturer
mass of cab [canopy] [ROPS (roll-over operator protective structure)] [FOPS (falling-object operator protective structure)] with all components and mountings required to secure it to the base machine
power obtained on a test bed at the end of the crankshaft or its equivalent, at the corresponding engine speed, with the equipment and auxiliaries listed in ISO 15550:2002, Table 1, column 2, and required in column 3 (fitted for engine net power test)
Note 1 to entry: If the power measurement can only be carried out with a mounted gearbox, the losses in the gearbox should be added to the measured power to give the net engine power. [SOURCE: ISO 15550:2002, 3.3.3.1, modified.]
maximum speed that can be obtained on hard level surfaces in each of the forward and reverse gear ratios available.BS ISO 7134 pdf download.