BS ISO 6361-2:2014 pdf free

BS ISO 6361-2:2014 pdf free.Wrought aluminium and aluminium alloys一Sheets, strips and plates
In conjunction with ISO 6361-1, this part of ISO 6361 specifies the mechanical properties of wrought aluminium and aluminium alloy sheets, strips, and plates for general engineering applications.It applies to flat-rolled products.
The chemical composition of these materials is given in ISO 6361-5.
The designations of aluminium and aluminium alloys and the temper designations used in this part of ISO 6361 are in accordance with ISO 2107.
NOTE In certain countries, for purposes of mechanical properties, the thickness limit can be lowered to 0,15 mm by agreement between the purchaser and the supplier, in the case of sheets and strips.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document
(including any amendments) applies.
ISO 6361-1, Wrought aluminium and aluminium alloys一Sheets, strips and plates一Part 1: Technical conditions for inspection and delivery
For the purposes of this document, the terms and definitions given in ISO 6361-1 apply.
For the selection of the specimens and tensile testing, see ISO 6361-1.
For the selection of the specimens and bend testing, see ISO 6361-1.
Values for mechanical properties of aluminium and aluminium alloys are given in Tables 1 to 63.For elongation, two different gauge lengths are used. The choice of the gauge length for elongation measurements (A or A50mm) is at the discretion of the producer, unless otherwise agreed.
Sheet, strip, and plate shall be capable of being bent cold through an angle of 180°, as applicable, around a pin having a radius equal to k times the thickness, t, of the sheet, strip, or plate (for example 0,5t) without cracking. The values of the minimum bend radii for different alloys, tempers, and thicknesses are given in Tables1 to 63.
NOTE The explanations of the numbered notes in Tables 1 to 63 are given after Table 63.BS ISO 6361-2 pdf free download.