BS ISO 3466:2016 pdf free

BS ISO 3466:2016 pdf free.Machine taper pin reamers with parallel shanks
BS ISO 3466 lays down the dimensions of machine taper pin reamers with parallel shanks.It covers only metric dimensions, which are the only recommended dimensions in the future for these types of reamers.
The reamers have been designed to produce holes for taper pins manufactured to ISO 2339, in the range of 2 mm to 12 mm nominal diameter.
Unless otherwise stated, these reamers will be right-hand cutting.
The flutes may be straight or left-hand spiral at the option of the manufacturer.
Hand taper pin reamers are dealt with in ISO 3465, and machine taper pin reamers with Morse taper shanks in ISO 3467.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 4203, Parallel shank tools一Driving tenons and sockets一Dimensions
3 Driving tenons
The dimensions of the driving tenons for machine taper pin reamers with parallel shanks, when required, shall be in accordance with ISO 4203.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. ISO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the ISO list of patent declarations received (see www.iso.org/patents).
Any trade name used in this document is information given for the convenience of users and does not constitute an endorsement.
For an explanation on the meaning of ISO specific terms and expressions related to conformity assessment, as well as information about ISO’s adherence to the WTO principles in the Technical Barriers to Trade (TBT) see the following URL: Foreword-Supplementary information.
The committee responsible for this document is ISO/TC 29, Small tools, Subcommittee SC 9, Cutting tools with defined cutting edges, cutting items.
This second edition cancels and replaces the first edition (ISO 3466:1975), of which it constitutes a minor revision.BS ISO 3466 pdf free.