BS ISO 2296:2018 pdf free
BS ISO 2296:2018 pdf free.Metal slitting saws with fine and coarse teeth一Metric series
This document specifies the dimensions and the mechanical characteristics of metal slitting saws,metric series. It applies to the following two types of metal slitting saws:
一metal slitting saws with fine teeth;
一metal slitting saws with coarse teeth.
If there is a need to extend the range or introduce other series of teeth, it is intended that such additions be according to the data given in the graph in Annex A.
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 240, Milling cutters一Interchangeability dimensions for cutter arbors or cutter mandrels
ISO 2924, Solid and segmental circular saws for cold cutting of metals一Interchangeability dimensions of the drive一Saw diameter range 224 to 2 240 mm
No terms and definitions are listed in this document.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
一ISO Online browsing platform: available at https://www.iso.org/obp
一IEC Electropedia: available at http://www.electropedia.org/
The ratio between the number of teeth for saws with coarse teeth and the number of teeth for saws with fine teeth is 0,5 and specific values are related to saw diameter and thickness.
The dimensions of metal slitting saws with fine teeth shall be in accordance with the indications given in Figure 1 and Table 1.
Metal slitting saws may have side relief up to the bore or up to a hub diameter, d3. The side relief shall be at the manufacturer’s discretion.
Metal sitting saws are generally supplied without keyways. The execution of the keyway, by agreement between the user and the manufacturer, shall be in accordance with the dimensions given in ISO 240.
By agreement between the user and the manufacturer, metal slitting saws of diameters d2 = 200 mm,d2 = 250 mm and d2 = 315 mm may be supplied with pin hole drives. The number of these holes, their drilling diameters and their pitch circle diameters shall be in accordance with ISO 2924.BS ISO 2296 pdf free download.
