BS ISO 13976:2016 pdf free

BS ISO 13976:2016 pdf free.Hot-rolled steel sheet in coils of structural quality and heavy thickness
If any test does not give the specified results, two additional tests shall be conducted on samples selected at random from the same lot. Both retests shall conform to the requirements of document;otherwise the lot shall be rejected.
The manufacturer has the right to resubmit, for acceptance, the products that have been rejected during earlier inspection because of unsatisfactory properties, after the rejected products have been subjected to a suitable treatment (e.g. selection, heat treatment, etc.) which, on request, will be indicated to the purchaser. In this case, tests shall be carried out as if they applied to a new lot.
The manufacturer has the right to present the rejected products for re-examination for compliance with the requirements for another grade.
The surface condition shall be that normally obtained for a hot-rolled product.
Processing for shipment in coils does not afford the manufacturer the opportunity to observe readily or remove non-conforming portions, as is possible on cut length products. However, this does not relieve the manufacturer of responsibility to provide a product that meets the requirement for surface condition that is normally obtained on a hot-rolled product.
Although not usually required for products covered by this document, when the purchaser specifies that inspection and tests for acceptance shall be observed prior to shipment from the manufacturer’s works, the manufacturer shall afford the purchaser’s inspector all reasonable facilities to determine that the steel is being furnished in accordance with this document.
Steel that is reported to be non-conforming after arrival at the user’s works shall be set aside,properly and correctly identified and adequately protected. The manufacturer shall be notified in order that the reported non-conforming material may be properly investigated.
When ISO 13976 is ordered in coils. A minimum or range of acceptable inside diameter(s) (ID) or range of acceptable inside diameters shall be specified. In addition, the maximum outside diameter (OD) and the maximum acceptable coil mass shall be specified.BS ISO 13976 pdf download.