BS ISO 1206:2016 pdf free
BS ISO 1206:2016 pdf free.Rolling bearings一Needle roller bearings with machined rings
BS ISO 1206 specifies the boundary dimensions and normal class tolerance values for needle roller bearings with machined rings.
This International Standard specifies dimensional and geometrical characteristics, limit deviations from nominal sizes.
These specifications apply to complete needle roller bearings and to bearings without inner ring.
Recommended values for the tolerances for shaft raceways for needle roller bearings without inner ring are given in Annex A.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 582, Rolling bearings一Chamfer dimensions一Maximum values
ISO 1101, Geometrical product specifications (GPS)一Geometrical tolerancing一Tolerances of form, orientation, location and run-out
ISO 5593, Rolling bearings一Vocabulary
ISO 5753-1, Rolling bearings一Internal clearance一Part 1: Radial internal clearance for radial bearings
ISO 14405-1, Geometrical product specifications (GPS)一Dimensional tolerancing一Part 1: Linear sizes
ISO/TS 17863, Geometrical product specification (GPS)一Tolerancing of moveable assemblies
ISO 15, Rolling bearings一Radial bearings一Boundary dimensions, general plan
ISO 286-1, Geometrical product specifications (GPS)一ISO code system for tolerances on linear sizes一Part 1: Basis of tolerances, deviations and fits
ISO 286-2, Geometrical product specifications (GPS) 一ISO code system for tolerances on linear
sizes一Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
ISO 1132-1, Rolling bearings一Tolerances 一Part 1: Terms and definitions
ISO 2639:2002, Steels 一Determination and verification of the depth of carburized and hardened cases
ISO 5459, Geometrical product specifications (GPS)一Geometrical tolerancing一Datums and datum systems
ISO 8015, Geometrical product specifications (GPS)一Fundamentals 一Concepts, principles and rules
ISO 14253-1, Geometrical product specifications (GPS)一Inspection by measurement of workpieces and measuring equipment一Part 1: Decision rules for proving conformity or nonconformity with specifications
ISO 14253-2, Geometrical product specifications (GPS)一Inspection by measurement of workpieces and measuring equipment一Part 2: Guidance for the estimation of uncertainty in GPS measurement,in calibration of measuring equipment and in product verification
ISO 14638, Geometrical product specifications (GPS)一Matrix model
ISO 15241, Rolling bearings一Symbols for physical quantities.BS ISO 1206 pdf download.
