BS ISO 104:2015 pdf free

BS ISO 104:2015 pdf free.Rolling bearings一Thrust bearings一Boundary dimensions, general plan
BS ISO 104 specifies preferred boundary dimensions for single- direction and double-direction thrust bearings with flat back faces.
In addition, it gives the minimum bore diameters of housing washers and maximum outside diameters of shaft washers of bearings in dimension series 11, 12, 13, 14, 22, 23 and 24.
Guidelines for the extension of this International Standard for single-direction thrust bearings are given in Annex A.
NOTE Boundary dimensions for aligning thrust bearings (none flat back faces) and aligning seat washers are given in ISO 20516.[2]
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 582, Rolling bearings一Chamfer dimensions一Maximum values
ISO 5593, Rolling bearings一Vocabulary
ISO 15241, Rolling bearings一Symbols for physical quantities
For the purposes of this document, the terms and definitions given in ISO 5593 and the following apply.
thrust rolling bearing with flat back faces intended to support axial load in one direction only
thrust rolling bearing with flat back faces intended to support axial load in both directions
central washer which is intended to be mounted on a shaft[SOURCE: ISO 20516:2007, 3.5]
The symbols shown in Figures 1 and 2 and the values given in Tables 1 to 9 denote nominal dimensions,unless specified otherwise.
B height of central shaft washer
D outside diameter of housing washer
D1 bore diameter of housing washer
D1smin smallest single bore diameter of housing washer
d bore diameter of shaft washer, single-direction thrust bearing with flat back faces
d1 outside diameter of shaft washer, single-direction thrust bearing with flat back faces
d1smax largest single outside diameter of shaft washer
d2 bore diameter of central shaft washer, double- direction thrust bearing with flat back faces
d3 outside diameter of central shaft washer, double-direction thrust bearing with flat back faces.BS ISO 104 pdf download.