AS 4287:2016 pdf free
AS 4287:2016 pdf free.Child use and care articles – Child seats for cycles – Safety requirements and test methods ( EN 14344:2004, MOD)
Take measurements relative to the points on the reference plane of the measuring instrument as follows (see Figure A.2):
a) measure the inside width of the seat, through point B ; check that this complies with the requirements given in Table2, line a ;
b) slide the 60 mm by 15 mm diameter pllar along the thigh scale until it touches the edge of the seat. The seat length is the distance between the edge of this pillar and point A ; check that this complies with the requirements given in Table 2, line b ;
c) measure to the top centre of the backrest from point A. Take the linear distance between these two points using a calliper, or, if using the measuring instrument as shown, calculate from the vertical and horizontal displacement relative to point A ; check that this distance complies with the requirements given in Table 2,line C. If the child seat is ftted with an adjustable headrest measure to the top centre of the headrest, the headrest being in the lowest position ;
d) measure vertically above point B to a horizontal straightedge laid across the seat sides ; check that this distance complies with the requirement given in Table 2, line d ;
e) measure the maximum overall width and length of the area intended to support the child’s foot, and check that the dimensions comply with the requirements, given in Table 2, line e ;
f) set the end of the thigh scale – the knee point E – to the shorter of the two distances h from point D, as specified in Table 2, line h. Adjust the footrest to its highest position. Using the leg and foot component of the measuring instrument with the heel against the back of the footrest, check that the distance from E to F is not more than the smaller value of f (given in Table 2, line f). Re-set the knee point to the longer of the two distances h, adjust the footrest to its lowest position and check that the distance E to F is not less than the larger value of f (given in Table 2, line f) ;
g) place a vertical straightedge on the reference plane touching the front edges of the seat sides. Check whether point C is between the straightedge and backrest of the seat.AS 4287 pdf free.
