AS ISO 11862:2021 pdf free
AS ISO 11862:2021 pdf free.Earth-moving machinery一Auxiliary starting aid electrical connector
AS ISO 11862 specifies the details, dimensions and design of both plug (male) and receptacle (female) which must mate properly to permit interchangeable use of different makes of electrical connectors providing an auxiliary starting circuit for earth-moving machinery as defined in ISO 6165. It lays down a universal connecting device, with correct polarity, standard circuit coding and protection from electrical shorts, which may also be used with any other machinery, vehicle or automotive equipment with the same electrical system voltage range.
The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below.
Members of IEC and ISO maintain registers of currently valid International Standards.
ISO 6165:1987, Earth-moving machinery一Basic types一Vocabulary.
ISO 9247:1990, Earth-moving machinery 一Electrical wires and cables一Principles of identification and marking.
IEC 228:1978, Conductors of insulated cables.
IEC 245-4:1980, Rubber insulated cables of rated voltages up to and including 450/750 V一Part 4: Cords and flexible cables.
IEC 269-1:1986, Low-voltage fuses一Part 1: General requirements.
The receptacle assembly shall be as shown in figure 1 and shall be permanently installed in a machine.The receptacle contains the male terminals [see figure 3 b]; the configuration shall provide positive means of ensuring correct polarity when coupled with the mating plug.
The plug assembly shall be as shown in figure 2; it provides auxiliary starting from one machine to another [see figure 2 a)], or from an external power source, such as a battery cart, to the machine [see figure 2 b]. The plug contains the female terminals [see figure 3 a)] and mates with the receptacle assembly in 3.1.
Terminals shall be in accordance with figure 3 and permanently attached to the cable ends before moulding, by soldering, brazing, welding or by other suitable method to provide a connection which will be mechanically and electrically secure.AS ISO 11862 pdf free download.
