AS 2210.2:2019 pdf free

AS 2210.2:2019 pdf free.Personal protective equipment
Place the test piece on the plate in such a way that the steel nail can penetrate it through the bottom.Press the nail against the sole unit at a speed of (10±3) mm/min until the point has penetrated completely and measure the maximum force.
Carry out the test at four different points on the sole unit (at least one in the heel region) with a minimum distance of 30 mm between any two penetration points and a minimum distance of 10 mm from the edge of the insole. For cleated soles, carry out the test between cleats. Two of the four measurements shall be made at a distance of 10 mm to 15 mm from the line represented by the feather edge of the last.
Run the testing machine at a speed of (10±3) mm/min up to the required force of 1 100 N (see 6.2.1),then stop the machine and carry out either the visual inspection within 10 s at an angle of(90±15)°to the nail axis or an electrical or cinematographic detection.
Carry out the test at four different points on the sole unit (at least one in the heel region) with a minimum distance of 30 mm between any two penetration points and a minimum distance of 10 mm from the edge of the insole. For cleated soles, carry out the test between cleats. Two of the four measurements shall be made at a distance of 10 mm to 15 mm from the line represented by the feather edge of the last.
The electrical resistance of conductive footwear is measured after conditioning in a dry atmosphere [5.10.3.3 a]. The electrical resistance of antistatic footwear is measured after conditioning in a dry atmosphere and afterwards conditioning in a wet atmosphere [5.10.3.3 a) and b)]. If there are enough samples, the two conditionings can be conducted in parallel.
If the footwear has been supplied with a removable insock, carry out the test with it in place. Clean the surface of the sole of the footwear with ethanol to eliminate all traces of mould silicone, wash with distilled water and allow drying at(23±2) °C. The surface shall not be buffed or abraded or cleaned with organic materials which attack or swell the sole.AS 2210.2 pdf free download.