AS NZS 62841.2.10:2018 pdf free
AS NZS 62841.2.10:2018 pdf free.Electric motor-operated hand-held tools,transportable tools and lawn and garden machinery – Safety
Compliance is checked by measurement and by calculations as follows:The moment arm of each handle (a) is determined as illustrated in Figure 102. The sum of the moment arms of the two handles shall be greater than or equal to the diameter or width of the largest recommended mixer basket in accordance with 8.14.2 a) 101). If there are more than two handles, then the worst case configuration in accordance with 8. 14.2 b) 6) shall be used,with one of the handles incorporating the power switch.
For mixers with more than one spindle, the spindles shall be adequately spaced in order to reduce the risk of entanglement. The minimal clearance C between rotating parts ir the area of the spindle outputs and along further 100 mm down to the mixer basket shall be at least 40 mm, see Figure 103.
Chuck keys shall be so designed that they drop easily out of position when released.This requirement does not exclude the provision of clips for holding the key in place when not in use; metal clips fixed to the flexible cable or cord are not allowed.
Mixers are subjected to three impacts that result from the tool being tipped over to strike a concrete surface. The tool is tipped with the longest mixer basket, including extensions, if applicable, recommended by the manufacturer in accordance with 8.14.2 a) 101). If no length of the recommended mixer basket is specified, the tip test is performed with a mixer basket of 1 m length. The tool is positioned in an upright position with the tip of the mixer basket resting on the concrete surface. The tool is then tipped in three different directions on to the concrete surface.
With the power switch in the“on” position, the lock-on device shall not be actuated by a straight edge 25 mm long when the straight edge is pushed down on the lock-on device. The straight edge shall be oriented in any direction and be applied to bridge the surface of the lock-on device and any surface adjacent to the lock-on device.AS NZS 62841.2.10 pdf free download.
