AS NZS 60335.2.97:2017 pdf free
AS NZS 60335.2.97:2017 pdf free.Household and similar electrical appliances – Safety
NOTE 101 Mechanical parts to take account of variations in the driven part can be included in a website,catalogue or similar reference.
The installation instructions shall state the substance of the following where applicable:
一before installing the drive, remove any unnecessary cords or components and disable any equipment not needed for powered operation;
一install the actuating member of any manual release at a height less than 1,8 m;
一that the actuating member of a biased-off switch is to be located within direct sight of the driven part but away from moving parts. It is to be installed at a minimum height of 1,5 m;
一information if the drive is intended to be installed at a height of at least 2,5 m above floor level or other access level.
For drives supplied without a driven part, the installation instructions shall state the substance of the following:
一that the characteristics of the driven part must be compatible with the rated load and rated operating time;
一the minimum tube diameter needed to insert tubular drives;
一how to assemble the driven part and how to adjust the controls.
The installation instructions for awnings shall state that a horizontal distance of at least 0,4 m is to be maintained between the fully unrolled driven part and any permanent object.
Tubular drives are installed in a tube that is open at both ends and has the largest diameter specified in the instructions. The tube has a length twice that of the motor and is mounted on a support as in normal use. The support is rotated at a speed of 1 r/min.
Tubular drives with a rolling driven part are tested with the driven part fully extended. At the end of the test the mains supply is reconnected and the driven part is fully retracted.AS NZS 60335.2.97 pdf free download.
