BS ISO 24035:2014 pdf free

BS ISO 24035:2014 pdf free.Belt drives一V-belts and the corresponding pulleys for agricultural machineries
BS ISO 24035 provides dimensional details of the V-drive belts used on agricultural machinery. It is intended to reflect practice (at the time of publication) in the design of such drives and to provide, where practicable, links to International Standards for similar belts used on industrial machinery.
NOTE All dimensions in this International Standard are in millimetres (mm).
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 1081, Belt drives一V-belts and V-ribbed belts, and corresponding grooved pulleys一Vocabulary
ISO 4183, Belt drives一Classical and narrow V-belts一Grooved pulleys (system based on datum width)
ISO 5290, Belt drives一Grooved pulleys for joined narrow V-belts一Groove sections 9N/J, 15N/J and 25N/J (effective system)
ISO 5291, Belt drives一Grooved pulleys for joined classical V-belts 一Groove sectionsAJ, BJ, CJ and DJ (effective system)
ISO 9982, Belt drives一Pulleys and V-ribbed belts for industrial applications- PH, PJ, PK, PL and PM profiles: Dimensions
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 1081 apply.
4 Symbols
For the purposes of this document, the symbols given in ISO 1081 apply.
5 Belt cross-sections and nominal dimensions
The belt cross-section is characterized by the top width, W, and height, hb. In the case of joined V-belts and V-ribbed belts, the cross-section spacing is also relevant. The angle of the belt sides is usually 40° except in the case of variable speed belts where the angle is commonly 32° but may be different on some
applications.
The nominal dimensions of belt cross-sections are shown in Table 1 and Figure 1.
The belt cross-sections supplied by different manufacturers may vary slightly due to manufacturing methods and/or the tooling used. All belts of a given cross-section shall work in the pulley grooves specified in this International Standard for that section.BS ISO 24035 pdf download.